| |
Edge Shield Moc1 Coping System (available Flat and Tapered)
|
|
|
The Edge Shield Moc1 Coping System is a time proven and economical design. It incorporates a continuous hold down cleat
on the front side and fasteners at the rear. A wood nailer or substrate sufficient to hold fastener at rear face is required.
This system has been tested to meet ANSI/SPRI ES-1 requirements for wind uplift.
|
|
| |
Edge Shield Moc2 Coping System (available Flat and Tapered)
|
|
The Edge Shield Moc2 Coping System incorporates individual anchor plates of 20 gauge galvanized steel. Installed at 5'-0" on center,
the plates eliminate exposed fasteners and allow the coping to be installed directly atop a masonry wall without a wood nailer.
|
|
| |
Edge Shield Moc3 Coping System (available Flat and Tapered)
|
|
|
The Edge Shield Moc3 Coping System is similar to the Moc2 substituting the individual anchor plates with 20 guage spring plates. This system has been tested to meet ANSI/SPRI, ES-1 ratings.
|
|
